Diamond Multimedia WR300N Manual do Utilizador

WR300N Portable Wireless-N Repeater Quick Start Guide

Double click on the Ethernet network name of your wired Ethernet port. See example below: Click on the “Details” tab as shown below:

Notice the IPv4 Address is 10.0.10.1, this is correct. The IP address you receice may vary. Example you may get 10.0.10.2, 10.0.10.3, but notice the f

Make sure you select “Use the following IP address” option and enter 10.0.10.1 for the IP address. Enter 255.255.255.0 for the Subnet mask. Enter 10.

Once completed proceed back to step 4 of this guide to complete the WR300N configuration. Note: after you have finished setting up the repeater using

Technical Support Diamond Technical Support staff is here to help resolve any issues that you may be experiencing. Prior to contacting technical suppo

Minimum System Requirements To configure your WR300N repeater your computer must meet the following minimum requirements. Any operating system can be

Device Overview Front Panel

Configuring the Repeater Setting up the device is easy. Follow the steps below to configure the device for your current wireless router/AP. Ensure to

3. Once a connection to the WR300N is established, your PC/laptop will receive an IP address and you can start the configuration using the web graphic

NOTE: If you are connecting to a hidden wireless network, you need to go through the Manual Setup and key-in the information from your existing wirel

Now, Plug the WR300N back to a power outlet at the best determined location. Notes: it is always best to place the repeater half way between your dead

Click on “Network and Internet” as shown below: Click on “View network status and tasks” as shown below:

Click on “Change adapter settings” as shown below: